I need to set my page size to 8.5" horizontal by 7.375" vertical. However, in CR2008 when the vertical size is less than the horizontal, it automatically flips the orientation to landscape. On a modern printer, this might not be a big deal. You can usually flip the output 90 or 180 degrees. Unfortunately, I am working on a Okidata ML320 dot matrix printer and pre-printed forms.
Does anyone know a way to work around this issue. I have tried setting the page size to 8.5H x 8.5V and then setting the bottom margin 1.125 but that causes a pagination problem when the printer advances for tear off purposes.
Any suggestions would be appreciated.
Gilley