Crystal Reports vertical sections

Report Design
Crystal Reports Forum : Crystal Reports .NET 2003 : Report Design

Topic: vertical sections

Author	Message
raiyan Newbie Joined: 11 Jan 2007 Online Status: Offline Posts: 6	Topic: vertical sections Posted: 20 Apr 2007 at 1:56am
	Hello everyone, I want to set the sections in crystal report vertically insted of horizontally as they are seen by default. Is there any way to do so ?
	:)
	IP Logged

hilfy Admin Group Joined: 20 Nov 2006 Online Status: Offline Posts: 3701	Posted: 20 Apr 2007 at 12:14pm
	No, there's not. But you might be able to use subreports to simulate it. -Dell
	Proviti, Data & Analytics Practice www.protiviti.com/US-en/data-management-advanced-analytics
	IP Logged

raiyan Newbie Joined: 11 Jan 2007 Online Status: Offline Posts: 6	Posted: 21 Apr 2007 at 6:15am
	Thanks for the reply Dell. Aren't the subreporst supposed to be put inside sections ? then I am stuck with the horizontal thing again. Correct me if I am wrong.
	:)
	IP Logged

hilfy Admin Group Joined: 20 Nov 2006 Online Status: Offline Posts: 3701	Posted: 23 Apr 2007 at 7:36am
	Yes, but you set the width of the subreports in the main report, so you can have them side-by-side in the same section. -Dell
	Proviti, Data & Analytics Practice www.protiviti.com/US-en/data-management-advanced-analytics
	IP Logged

raiyan Newbie Joined: 11 Jan 2007 Online Status: Offline Posts: 6	Posted: 23 Apr 2007 at 9:41am
	Thanks for enlightening me. I will try that as soon as I am finished with the works at hand.
	:)
	IP Logged

Post Reply

Post New Topic

Printable version

Printable version

Forum Jump

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

This page was generated in 0.031 seconds.