This is not too difficult.
1. Create a second page header section that will print ONLY on the even numbered pages. Put your T&C text in this section.
2. Go to the Section Expert.
3. Select the new Page Header section and click on the button to the right of "Suppress" (do NOT check the Suppress checkbox!).
4. In the formula, enter the following:
PageNumber mod 2 > 0
This will suppress the section if the report is not on an even numbered page.
5. If you have a Page Header section that you do NOT want to print on the even-numbered pages, select the section and click on the Suppress formula button as in step 3. Enter the following:
PageNumber mod 2 = 0
If you make the new page header section tall enough (roughly paper size - top and bottom margins from Page Setup - height of page footer section), then you probably don't have to do anything else to get this to come out correctly. However, if you get data or anything else on the T&C page that you don't want to have, you can suppress those sections using the same formula as in step 5 above.
-Dell
IP Logged
