Hi
I have a problem with top and bottom margins in my report. In the designer view - File>Page Setup - I have the paper size (A4 210X297 cm). Both the top and bottom margins are set to 2 cm which, If I understand it correctly, printing should start exactly 2 cm from the top and end at 2 cm from the bottom of a page.
However, no matter what I do, it starts printing 1.5 cm from the top and ends at 3 cm from the bottom of a page.
I have the 'Dissociate Formatting page size and printer paper size turned off so that should not influence anything and even if it's turned on makes no difference.
In Designer view when I look at the ruler the Report Header - it is exactly 25.5 cm in length. For some reason unknown to me I can't make it any longer. If I add even 1 or 2 mm to the length, the printing spills over to a new page.
I'm printer to a HP laser printer - nothing fancy - other programs like Word prints to the same printer with no margin issues whatsoever.
I will appreciate it so much if someone can point me in the right direction, please.
Kind Regards
Danie
IP Logged