As it turns out the problem was with the conditions I had set up to add to the total.  But now I have come up with a new problem, but similar.

 

I have 3 groups.  warehouse, part, location.  The problem I am getting now is the totals of the parts to display.  On the detail line I can have a running total by location, so I have the total I want to print on the last line of the locations.  But If I move it to an @print formula, and then try to print, I only get zeros.  I am initializing the @print, and have tried it in every header area.  I only want to print totals when part  changes.  I tried to use the same set of formulas I used for the grand total for the part subtotals.

 

I hope I am clear. 

 

Again, thank you for your help.

Thank you for your help.  It was good to write out the problem and that way think it out.