Greetings,

I have a report with the typical sections of Crystal Report for VS2008.NET
In the details section I have a break "New page after" subject to 100 records. Ie, after 100 records printed in the detail begins a new page.
The problem is as follows: section 1 (Report Header) there are certain fields that must be filled out by hand when handling the printed sheet.

The Report Header to be printed each time that happens the condition of 100 records. This does not.

What should I do with the shape or section, so that after every 100 records begin on a new page and print again on Report Header records with the next 100?

Thanks for your help

Hilfy

First, thank you very much for your prompt response.

Make the changes you suggested about the change of section and the condition to show or hide the section.

It works well but only partially, ie the first 100 records show only the Page Header on the first page. Once you complete the 100 records began on a new page with the Page Header (correct) but the page immediately to the (records of approximately 130 to 156) are again on Page Header (Wrong) and from there the behavior is a little unstable.


The condition is Supress:
not onfirstrecord and recordnumber \ 100 <> 1

I applied similar conditions but with the same result.

What could be doing wrong that this behavior creates the report?


Thank you

Yes, I have such a field  (Running total) and shows the correct numbers in the detail of 1 to 1.

I also have two sections or groups to stop ordering and grouping of these data, it will have something to do with the condition of choice?

I have revised and developed multiple times by multiple ways and always presents a behavior not expected.

Good day hilfy,

 

The record breaking 100 runs perfectly. What is not working well or not is the appearance of the header and Page Header.

Is it possible to apply a kind of trigger to be met at the 100 records and the header (Page Header) is displayed as indicated by the trigger rather than a formula?

 

Thanks...