hi all,
First of I would like to make the attention to moderators/owners of this site.
I was creating a new post and have almost done but accidently pressed CTRL + R and it has gone for new post again and my previous post that i was going to post.
and when i press back button to check if I can get it again because below is the post that i have typed and lost becoz of CTRL + R then the edit box for writing the post was empty
So I request if possible then either prompt before showing navigating to new post again, so that accidently users can't loss there posts before posting it.
I hope i have cleared what I want to say.
Now here is my question again and hope this time I will do copy after typing some text and will not press any other shortcut key:
I have main report and a sub report and i am accepting one parameter in my main report say nRecNo.
e.g. main report command:
select * from mytable where recid = {nRecNo}
now in my sub report command I want to access this parameter (nRecNo) to fetch records
something like this:
select * from myOtherTable where someField = {baseReportCommand.nRecNo}
I have related the sub report with main report by using (Report > selection formula > record):
{Command.code} = {?Pm-Command.recid}
but I need to put base report parameter in sub report command's where condition (if it is possible).
Is it possible to access base repot parameter in sub report's command?
TIA,
Surinder Singh
IP Logged
