Crystal Reports New page problem

Technical Questions

Crystal Reports Forum : Crystal Reports 9 through 2022 : Technical Questions

Topic: New page problem

Post Reply

Post New Topic

Author	Message
richboy7 Newbie Joined: 24 Nov 2008 Online Status: Offline Posts: 2	Topic: New page problem Posted: 24 Nov 2008 at 8:03pm
	If I have data in group; group1 detail1 detail2 detail3 group2 detail1 detail2 detail3 group3 detail1 detail2 detail3 detail4 When printing I want to start new page when at the bottom of the page contain only the header of group or contain group header and only 1-2 detail. How can I do this?
	IP Logged


lockwelle Moderator Joined: 21 Dec 2007 Online Status: Offline Posts: 4374	Posted: 25 Nov 2008 at 6:25am
	I have tried various methods, but the one that seems to work the best is...Go to your group line, right click on the left side of the screen (in the gray) and 'Change Group', Options tab, place a check in 'Keep Group Together'. For the most cases, Crystal will insert the page break and will do its best to keep the group together. Found this originally in another post on this site. Hope this is what you were looking for.
	IP Logged

richboy7 Newbie Joined: 24 Nov 2008 Online Status: Offline Posts: 2	Posted: 27 Nov 2008 at 9:12pm
	Thank you for your answer. I did that also. However, sometimes the big group will begin with the new page and leave the blank for a half page before the new page. I hope there are some how to chechk that only header of group or only one or two detail line, then begin a new page. Anyway, Thank you very much.
	IP Logged

Printable version

Printable version

Forum Jump

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum