Report Design
 Crystal Reports Forum : Crystal Reports 9 through 2020 : Report Design
Message Icon Topic: Multivalue Parameter in Command? Post Reply Post New Topic
Author Message
XstalPat
Newbie
Newbie


Joined: 27 Jul 2017
Online Status: Offline
Posts: 1
Quote XstalPat Replybullet Topic: Multivalue Parameter in Command?
    Posted: 28 Jul 2017 at 3:05am
This issue has gone back since 2007, was this issue ever resolved? I've encountered this issue now in CR XI, is there a workaround?

Multivalue Parameter in Command

Thanks
IP IP Logged
Sastry
Moderator
Moderator
Avatar

Joined: 16 Jul 2012
Online Status: Offline
Posts: 537
Quote Sastry Replybullet Posted: 29 Jul 2017 at 12:33am
Hi

This was addressed in Crystal Reports 2008, while creating parameter it self it will ask you to check a box if the parameter has multi selection.

Work around for this problem is:

Create a blank report, with a parameter (if this is dynamic then select the table else select static values)
Now, insert your report as sub report and link main report parameter to sub report parameter. Then go in command where clause mention some thing like :

{databasefiled} in ({?parameter})

Thanks,
Sastry
Thanks,
Sastry
IP IP Logged
Post Reply Post New Topic
Printable version Printable version

Forum Jump
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum



This page was generated in 0.016 seconds.